6.1 Common Specifications
6-3
Chap. 6
CONTROL OPTIONS
The following table indicates which control options can be used in combination (number of options
mountable):
Table 6.1.2
CN Port Category Pattern 1 Pattern 2 Pattern 3
3 A Digital 8-bit, analog card 1 1 1
2 B Digital 8-bit 1 0 0
6 C Filed bus interface card 0 0 1
10 D Digital 16-bit 1 1 0
16 E Safety cards 0 1 1
1 F Control circuit terminals 1 1 1
Constraints when an OPC control option is installed
Table 6.1.3 indicates which options can be used simultaneously.
OK: Can be used simultaneously. NG: Cannot be used simultaneously.
Table 6.1.3
Model
OPC-VG1-_ _ _ _
SN FV AIO DI DIO TL CCL PG PMPG SPGT SIU SX ESX UPAC PNET PDP DEV SAFE TBSI
SN NG
FV NG NG
AIO NG NG NG
DI OK OK OK OK
DIO OK OK OK OK OK
TL OK OK OK OK OK NG
CCL OK OK OK OK OK NG NG
PG/PGo OK OK OK OK OK OK OK *2
PMPG/PMPGo OK OK OK OK OK OK OK *2 NG
SPGT *1 *1 *1 OK OK OK OK NG NG NG
SIU OK OK OK OK OK OK OK OK OK OK NG
SX OK OK OK OK OK OK NG OK OK OK NG NG
ESX OK OK OK OK OK NG NG OK OK OK NG NG NG
UPAC OK OK OK OK OK OK OK OK OK OK OK NG NG NG
PNET OK OK OK OK OK NG NG OK OK OK NG NG NG NG NG
PDP OK OK OK OK OK NG NG OK OK OK NG NG NG NG NG NG
DEV OK OK OK OK OK NG NG OK OK OK NG NG NG NG NG NG NG
SAFE OK OK OK OK OK OK OK OK OK OK OK OK OK OK OK OK OK NG
TBSI OK OK OK OK OK OK OK OK OK OK NG OK OK OK OK OK OK OK NG
*1 Contact your Fuji sales representative if you need to use this combination of options.
*2 When the PG interface card (OPC-VG1-PG/PGo) and PMPG interface card (OPC-VG1-PMPG/PMPGo) are
mounted concurrently, the following constraints apply.
VG1-PG/PGo(SD) VG1-PG/PGo(LD) VG1-PG/PGo(PR) VG1-PG/PGo(PD)
VG1-PG/PGo(SD)
VG1-PMPG/PMPGo
NG
VG1-PG/PGo(LD) OK NG
VG1-PG/PGo(PR) OK NG NG
VG1-PG/PGo(PD) OK NG NG NG
To Next Page
Loading...
