GW Instek LCR Series - Page 92

Examples
88
6. Move to the SHORT TEST or SPOT
field using the cursor keys.
7. Connect the clips to a shorting bar as
shown below:
8. Press the [MEAS SHORT] soft-key and
then the [OK] soft-key. Wait until the
“Correction finished” message is
displayed.
9. Press the [ON] soft-key if the SHORT
field is set to OFF.
Step 5. Connect the DUT to the test fixture as shown
below:
Step 6. Press the [Measure] key. Measurements are
All manuals and user guides at all-guides.com