Safety Information
Chapter 1: Introduction
1 - 6 Affinity® Four Birthing Bed Service Manual (195826 REV 2)
The supports are intended to be used in the prescribed manner only. Failure to use this product as
outlined may cause personal injury or equipment damage.
Failure to unplug the bed could cause injury or equipment damage.
The voltage in the electrical system presents an electrical shock hazard. Do standard electrical service
procedures before attempting service within the P.C. board enclosure. Follow all electrical safety
precautions when servicing the bed’s electrical system. Failure to do so could cause personal injury or
equipment damage.
Do not expose the unit to excessive moisture which would allow liquid to pool. Personal injury or
equipment damage could occur.
Disconnect the battery if the bed will not be in service for extended periods of time. Failure to do so
could cause damage to the life of the battery, or damage to the bed. Contact the appropriate
maintenance persons.
Do not position the head of the bed against a wall or beneath any fixtures. This is to prevent damage
due to the arcing motion of the bed while the bed is being raised and lowered.
Make sure that the night light is not damaged when the bed is being lowered. Failure to do so could
cause equipment damage.
Do not pull on the mattress material when unfastening the mattress retaining snaps. Unfasten the
mattress retaining snaps at the snap location. Failure to do so could cause equipment damage.
Make sure that the fuse housing is correctly oriented for the voltage rating (110-120V or 220-240V) on
the bed that you are servicing. Failure to do so could cause equipment damage.
Do not cut or remove the cable ties that attach the battery leads to the electronics pan. This ensures the
proper connection of the batteries during the replacement procedure. Possible equipment damage
could occur if the cable ties are removed.
To Next Page
Loading...
