Safety Information
Chapter 1: Introduction
Affinity® Four Birthing Bed Service Manual (195826 REV 2) 1 - 7
1
To prevent component damage, make sure that your hands are clean, and only handle a P.C. board by its
edges. Failure to do so could cause equipment damage.
For shipping and storage, put the removed P.C. board in an antistatic protective bag. Failure to do so
could cause equipment damage.
Support the siderail during the removal procedure. Failure to do so could cause equipment damage.
Make sure that the siderail does not drop when the pins are removed. Failure to do so could cause
damage to the wiring going to the siderail.
Do not use harsh cleansers or detergents such as scouring pads and heavy-duty grease removers, or
solvents such as toluene, xylene, and acetone. Equipment damage could occur.
Make sure that the metal platform is dry before placing the mattress back onto the bed. Failure to do so
could cause equipment damage.
Mattress damage caused by improper draping and/or cleaning procedures is not covered by warranty.
Standard OB packs and paper drapes will not keep the sheets dry.
When handling electronic components, wear an antistatic strap. Failure to do so could cause
component damage.
Do not use silicone-based lubricants. Equipment damage could occur.
To Next Page
Loading...
