Hioki 8730-10 - Page 126

110
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
Relationship between original area
and compressed area
Increases in number
Move the cursor to right
Decreases in number
Select menu and Edit compression width (DIV,Time)
Move the cursor to left


↑:1DIV, ↓2DIV, ←1DIV, →2DIVの場合
→2DIV
↓2DIV
もとのエリア
圧縮されたエリア
↑1DIV
←1DIV
Com
p
ressed area
Ori
g
inal area
3. COMPRESS: Compress the area up or down and left or right
Compresses an object on the screen up and down, and left and right.
The compression width is defined by specifying the number of DIVs. The
time and voltage values corresponding to the number of DIVs appear
under the number of DIVs.
The "
BOX set
" command can be used for partial area compression.
Drawing Procedure
1. Use the
CURSOR
key to select
"
COMPRESS
" command, then press the
ENTER
key.
2. Use the up and down (voltage axis
direction) and left and right (time
axis direction)
CURSOR
keys to set the
compression width.
The number of DIVs defines the width.
The time and voltage axis values
corresponding to the number of DIVs
appear under the number of DIVs.
When scaling is ON, the scaled values
will be displayed. (The unit of measure
is abbreviated to the first two characters
only.)
3. Press the
START
key to start
compression.