113
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
"
POINT
" Mode
<<Related Issues>>
・Press the STOP key to
exit the "PAINT"menu.
・Press the CURSOR
SCROLL key to move the +
cursor fast (1 DIV each
movement). Pressing the
CURSOR SCROLL key
once again switches modes to
low-speed motion (dot-by-dot
movement
.
"
CLOSED
" Mode
6. PAINT: Fill the space surrounded by the closed curves with color
Fills the space surrounded by the closed curves. The filled-in space is the
comparison area.
There are two methods of filling in color:
(1) "
POINT
" mode : Fills the enclosed space selected by the cross cursor +.
(2) "
CLOSED
" mode: Fills all enclosed spaces you are working on. This is
useful for creating an area based on overlaid waveforms.
The "
BOX set
" command can be used for partial area filling.
Drawing Procedure
1. Use the CURSOR key to select "PAINT"
command, then press the
ENTER key.
2. Select a filling mode. The mode is set to
"
POINT" by default. Each pressing of the
ENTER key alternately selects one of the two
modes ("
POINT
"modeor"
CLOSED
"mode).
The currently selected mode is displayed at the
top of the screen.
3. Selecting "
POINT
" mode displays the + cursor
and the coordinates on the screen.
Move the + cursor to the enclosed space you
wish to fill, then press the
START key. Only
that space will be filled with color.
In "
CLOSED
" mode, press the
START
key to
fill all enclosed spaces with color.
To Next Page
Loading...
