Hioki 8730-10 - Page 130

114
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
Screen image after deletion with a range specified
7. BOX set: Specify the range of extension, compression, deletion, reversal,
and painting
Sets a range for the "
EXTEND
", "
COMPRESS
", "
CLEAR
", "
REVERSE
", or
"
PAINT
" command.
Sets a range by specifying the start and end points, and draws a rectangle
(box) with diagonal line specified by these two points. The specified
range is enclosed in a red frame.
The lines of the rectangle are included in the range.
Operation Procedure
1. Use the
CURSOR
key to select "
BOX set
"
command, then press the
ENTER
key.
2. The + cursor and the coordinates (X
coordinate, Y coordinate) are displayed
on the screen
3. Use the
CURSOR
key to move the +
cursor to the start point, then press the
ENTER
key.
4. Use the
CURSOR
key to move the +
cursor to the end point, then press the
ENTER
key.
5. A rectangle (box) with diagonal line
specified by the start and end points is
then confirmed.
6. To cancel the range, use the
CURSOR
key to select the "
BOXreset
" command,
then press the
ENTER
key.