116
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
Screen image of start point set for line
Screen image of end point set for line
Screen image of lines drawn continuously
from same start point
<<Related Issues>>
In step 3 above, pressing the STOP key after
setting the start point cancels the task of
drawing a line. Pressing the STOP key again
exits the "LINE" command.
In step 6 above, pressing the STOP key when
drawing lines continuously from the same start
point cancels the mode for the continuous
drawing of lines. Use this key to specify a new
start point. Pressing the STOP key again exits
the "LINE" command.
Press the CURSOR SCROLL key to make the
+ cursor move fast (1 DIV each movement).
Pressing the CURSOR SCROLL key once
again switches modes to low-speed motion (dot-
by-dot movement).
8-1. LINE: Draws a line.
Draws a line between the start and end points you specify.
Drawing Procedure
1. Use the CURSOR keytoselect"DRAWING"
command, then press the
ENTER key. The
DRAWING command menu will then
appear. Select the "
LINE" command, then
press the
ENTER key.
2. The + cursor and the coordinates (X
coordinate, Y coordinate) are displayed on
the screen
3. Use the
CURSOR
key to move the + cursor
to specify the start point, then press the
ENTER key to confirm the start point.
4. Specify the end point.
Use the
CURSOR key to move the + cursor.
A red line will appear between the start point
and + cursor. (Note that the line is not yet
confirmed.)
5. Press the
ENTER key to confirm the end
point and draw a green line between the start
and end points.
6. By moving the + cursor you can continue
drawing another line from the same start
point.
To specify a new start point, press the
STOP
key and repeat the steps from 3 above.
7. To exit the command, press the
STOP key.
8. To exit the DRAWING menu, select "
EXIT
"
and press the
ENTER
key. The editor
command menu then appears.
To Next Page
Loading...
