Hioki 8730-10 - Page 133

117
_____________________________________________________________________________________________
5.3 Creating Comparison Area
______________________________________________________________________________________________
"
RECT
"
"
RECT
"
<<Related Issues>>
In step 3 above, pressing the STOP key after
setting the start point cancels the task of
drawing a line. Pressing the STOP key again
exits the "ERCTANGLE" command.
Press the CURSOR SCROLL key to make the
+ cursor move fast (1 DIV each movement).
Pressing the CURSOR SCROLL key once
again switches modes to low-speed motion (dot-
by-dot movement).
8-2. RECT : Draw a rectangle and do not fill it in.
Draws a rectangle that has a line from two specified points at diagonal
corners. The rectangle will not be filled in.
8-3. RECT : Draw a rectangle and fill it in.
Draws a rectangle with diagonal line specified by two points. The
rectangle will be filled in.
Drawing Procedure
1. Use the CURSOR keytoselect"DRAWING"
command, then press the
ENTER key. The
DRAWING command menu then appears.
Select the "RECTANGLE" command, then
press the
ENTER key.
RECT
: Does not fill in the rectangle.
RECT
: Automatically fills in the
rectangle.
2. The + cursor and the X-Y coordinates will
appear on the screen.
3. Use the
CURSOR key to move the + cursor
for specifying the start point, then press the
ENTER key to confirm the start point.
4. Specify the end point. Use the
CURSOR
key
to move the + cursor. A rectangle with
diagonal line specified by the start point and
+ cursor is then drawn using a red line.
(The rectangle is not yet confirmed.)
5. Press the
ENTER key to confirm the
rectangle and change the line to green.
Selecting "
RECT
" fills in the rectangle.
6. To exit the command, press the
STOP key.
7. To exit the DRAWING menu, select "
EXIT
"
and press the
ENTER
key. The editor
command menu then appears.