Hioki 8730-10 - Page 145

129
_____________________________________________________________________________________________
5.5 Value Comparison Details
______________________________________________________________________________________________
最大値
T
最大値まで
の時間
Max.
Max-Time
最小値
Min.
最小値
T
最小値までの時間
Min.
Min-Time
周期T
1
[s] 周期T
2
[s] 周期T
3
[s] 周期T
4
[s]
指定レベル
Period T
1
[s]
Period T
2
[
s
]
Period T
3
[
s
]
Period T
4
[
s
]
Specified
level
(6) Max-Time
Obtains the time at which the
maximum value is measured
and obtains the difference
(time [s]) between that time
and the trigger time.
(Note that measuring the
maximum value before the
trigger due to pre-trigger will
result in a negative value.)
When the maximum value is
measured at multiple points,
only the first measurement is
used as the maximum value.
(7) Minimum
Obtains the minimum value [V]
for waveform data.
(8) Min-Time
Obtains the time at which the
minimum value is measured
and obtains the difference
(time [s]) between that time
and the trigger time.
(Note that measuring the
minimum value before the
trigger due to pre-trigger will
result in a negative value.)
When the minimum value is
measured at multiple points,
only the first measurement is
used as the minimum value.
(9) Period
Obtains the period T [s] of
waveform data.
Determines the period from
the intervals between the
points where the waveform
crosses the specified level in
the same slope direction, and
calculates maximum and
minimum values.
The diagram at the right shows an up-slope case.
(Maximum period) = max{T
i
}(i=1,2,3...)
(Minimum period) = min{T
i
}(i=1,2,3...)