32
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
2 seconds
6. Start measurement.
Press the
START
key. The LED above
the key will go on. In this example,
the 8730-10, 8731-10 has already
received input and the trigger is
activated immediately.
Since the trigger is set to "
Repeat
",
measurement will not stop
automatically even if the recording
length of data has been exceeded.
7. Stop measurement.
Press the
STOP
key. The LED above
the key will go out. Measurement is
interrupted.
8. Saves the screen as a bitmap file.
Hold down the
FILE
key for at least
two seconds to save the data in
bitmap format on the PC card.
To Next Page
Loading...
