Hioki 8730-10 - Page 49

33
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
EXTEND
1.00 DIV
1.00 DIV
0DIV
0DIV
Example 2) Create a comparison area using the loaded waveform and compare
the area.
1. Set the parameters via steps 1 to 5 of Example 1.
2. Load a waveform.
Press the
AREA EDIT
key to display
the Editor screen.
Select "
LOAD
" and set "
CH1
" as the
load source to load the CH1
waveform. (Set the mode to
"
LastWave
")
Press the
START
key to start loading.
3. Extend the loaded waveform data, and create a comparison area.
Use the
CURSOR
key to
set the extension width,
then press the
START
key.
4. Save the comparison area.
Select the destination at which to save
the comparison area.
Select the "
SAVE
" command, then
press the
ENTER
key. Select the area
No. and press the
START
key. In the
example, "
A01
"isselected.