Hioki 8730-10 - Page 50

34
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
Comp
Common Stop
Mode
Area or Value
Area (CH1)
Comparison ON
FAIL Mode OUT
Using Area A01
Stop Mode FAIL
The comparison result is PASS, with the waveform
shown a
g
ainst a
g
reen back
g
round.
The comparison result is FAIL, the waveform shown
a
g
ainst a red back
g
round.
5. Exit the Editor screen.
Select "
EXIT
" to end area edit.
6. Set the area comparison parameters. Press the
COMP SETTINGS
key.
7. Press the
START
key to start area comparison.
8. Press the
STOP
key to end the area comparison.