Hioki 8730-10 - Page 51

35
_____________________________________________________________________________________________
3.2 Basic Measurement and Setting
______________________________________________________________________________________________
Comp
Common Stop
Mode
Area or Value
Value
Measurement ON
No.1 Average
Comparison: OFF
No.2 RMS
Comparison: OFF
No.3 Frequency
Comparison: ON
Upper 1.01 k
Lower 980
No.4 Period
Comparison: OFF
Measure Range All Wave
Stop Mode FAIL
Example 3) Compare the value.
1. Set the parameters via steps 1 to 5 of Example 1 (except for setting the "
Info (left)
"to
"
CompResult
" in the step 3 measurement setting of Example 1).
2. Set the value comparison parameters.
3. Press the
START
key to start value comparison.