Hioki 8730-10 - Page 85

69
_____________________________________________________________________________________________
4.3 Details of Input Setting
______________________________________________________________________________________________
Increases in number
Moves the cursor
to the right
Decreases in number
Moves the cursor to the left
Confirms the number
0 0 0 . 0 0 0 0
A B
Setting Procedure
Value input screen
(A)
(B)
Entering values in Ratio Setting or Point Setting
Use the
CURSOR
keys and
ENTER
key to enter values. The function of
each key is shown in the figure below.
The input field is nine digits long (excluding the decimal point), as shown
in the figure below. Digits (A) and (B) are used for signs and prefixes.
The five most significant digits of numbers are effective.
(A): Displays a blank or -. A blank indicates a positive value; the -
indicates a negative value.
(B): Displays a blank or SI prefix. For details of SI prefix, see 13.2.5.
1. Setting the Scaling (OFF, ON)
Turns the scaling function ON/OFF.
Setting Procedure
1. Select "
Setting
" on the "Scaling" menu,
then press the
ENTER
key.
2. Select "
ON
"or"
OFF
", and press the
ENTER
key.
OFF: Does not perform scaling.
ON : Performs scaling and displays the
value with SI prefix. For details of SI
prefix, see 13.2.5.