70
_____________________________________________________________________________________________
4.3 Details of Input Setting
______________________________________________________________________________________________
Incline: Conversion ratio
Offset
EU
V
NOTE
2. Scaling in "Ratio Setting" (EU, OFFSET)
Scaling is performed by specifying a physical quantity to correspond to a
1 V input signal (conversion ratio: EU/V), an offset value, and the unit
(EU: Engineering Units). This will cause the measurement voltage to be
converted into the selected units.
Setting Procedure
1. Select "
Ratio Setting
" on the "
Scaling
"
menu, then press the
ENTER
key.
2. Enter a value for "
EU
".
3. Enter a value for "
OFFSET
".
The offset setting range is from -9.9999E+9
to 9.9999+9.
To Next Page
Loading...
