83
_____________________________________________________________________________________________
4.4 Trigger Functions
______________________________________________________________________________________________
上限値
下限値
T
T
U
er limit
Lower limit
上限値
下限値
T
U
er limit
Lower limit
[Window-in Trigger] [Window-out Trigger]
Increases in
number
Moves the cursor
to right
Decreases in
number
Editing Window-in/out Trigger
Moves the cursor to left
Confirms the
value
NOTE
Range Upper limit = A Lower limit = B Step
100 mV +1.1 V A B A B -1 V 0.0025 V
200 mV +2.2 V A B A B -2 V 0.005 V
500 mV +5.5 V A B A B -5 V 0.0125 V
1V +11 V A B A B -10 V 0.025 V
2V +22 V A B A B -20 V 0.05 V
5V +55 V A B A B -50 V 0.125 V
2. Window-in/out Trigger (Upper limit, Lower limit, Filter)
When using the window-in/out trigger, a trigger is activated when the
waveform enters or exits the range between the upper and lower limits of
the trigger level.
Using the trigger filter prevents an unintended trigger from being activated
by noise. (See 1. Level Trigger)
Setting the Window-in/out Trigger
1. On the trigger condition menu of a channel
(CH1 or CH2), select "
In
"or"
Out
", then press
the
ENTER
key.
2. Set the value of "
Upper
"
3. Then, set the value of "
Lower
".
The setting ranges of the upper and lower limits for the
window in/out trigger are as follows:
To Next Page
Loading...
