Hioki RM3545 - Page 87

4.6 Correcting Measured Values and Displaying Physical Properties Other than Resistance
79
4
4
Set the gain coefficient.
5
Set the offset.
Setting range: 0.2000×10
-3
to 1.9999×10
3
It is not possible to set the expo-
nent (E+3, etc.) directly. Use
and to multiply by 10
and 1/10 as necessary.
Move the cursor to the setting you
wish to configure. Make the value
editable with the key.
2
Move the cursor to the digit you
wish to set with the left and right
cursor keys. Change the value
with the up and down cursor keys.
Change
values.
1
Move among
digits.
3
Accept
( Cancel)
Multiply by 10.
Multiply by 1/10.
Clear value.
It is not possible to set the expo-
nent (E+3, etc.) directly. Use
and to multiply by 10
and 1/10 as necessary.
Move the cursor to the setting you
wish to configure. Make the value
editable with the key.
2
Move the cursor to the digit you
wish to set with the left and right
cursor keys. Change the value
with the up and down cursor keys.
Change
values.
1
Move among
digits.
3
Accept
( Cancel)
Multiply by 10.
Multiply by 1/10.
Clear value.
Setting range: 0 to ±9×10
9
(maximum resolution: 1 n, default: 0)