E1 Series Servo Drive Thunder Software Operation Manual Start Thunder
HIWIN MIKROSYSTEM CORP. 3-7
There are two communication ports on CN9, OUT port and IN port.
Figure 3.2.3.1.1
OUT: Connect to the IN port on other servo drive or other slave.
If the servo drive is the last station, do not connect to this port.
IN: Connect to controller (master), OUT port on other servo drive or other slave.
Here takes connecting two servo drives in serial as an example. Follow the procedure below to build the
multi-axes connection via mega-ulink.
1. Open Thunder, select ED1F (mega-ulink) in Drive type.
Figure 3.2.3.1.2
2. Select Network in Config. interface.
Figure 3.2.3.1.3
To Next Page
Loading...
