Honeywell HH490 - CHAPTER 10 - SECURITY; System Architecture; Connect with USB; Connect with RS232 Serial Port

HH490 User Guide 175
Selection
Setting
* Indicates default
Serial Command #
Indicates a numeric entry
Page
High Priority Symbology PRFCOD## 40
Low Priority Symbology PRFBLK## 41
Preferred Symbology Timeout (Range
100-3000) *500
PRFPTO#### 41
Preferred Symbology Default PRFDFT 41
Output Sequence Editor Enter Output Sequence SEQBLK 46
*Discard Partial Output Sequence SEQTTS0 48
Default Output Sequence SEQDFT 49
Require Output Sequence Required SEQ_EN2 50
On/Not Required SEQ_EN1 50
*Off SEQ_EN0 50
Good Read Tone - Output
Sequences
Good Read Beep - Each Code in
Sequence
BEPSIN0 50
*Good Read Click - Each Code in
Sequence
BEPSIN1 50
Good Read Beep - Partial Sequence
Output
BEPISE0 50
*Error Tone - Partial Sequence Output BEPISE1 50
Multiple Symbols On SHOTGN1 51
*Off SHOTGN0 51
No Read On SHWNRD1 51
*Off SHWNRD0 51
Video Reverse Video Reverse Only VIDREV1 52
Video Reverse and Standard Barcodes VIDREV2 52
*Video Reverse Off VIDREV0 52
Working Orientation *Upright ROTATN0
Vertical, Bottom to Top (Rotate CCW 90°) ROTATN1
Upside Down ROTATN2
Vertical, Top to Bottom (Rotate CW 90°) ROTATN3
Prefix/Suffix Selections
Add CR Suffix to All Symbologies VSUFCR 55
Prefix Add Prefix PREBK2## 55
Clear One Prefix PRECL2 55
Clear All Prefixes PRECA2 55
Suffix Add Suffix SUFBK2## 56
Clear One Suffix SUFCL2 56
Clear All Suffixes SUFCA2 56
Function Code Transmit *Enable RMVFNC0 56
Disable RMVFNC1 56