C
-
Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
NONE
This
hardkey
lets you select the center frequency for center
frequency/frequency span swept operation. When you press (CENTER),
the swept CW generator displays:
-->
CENTER:
XXXXX MHz
where
XXXXX represents a frequency value. Use the entry area to set the
desired value.
Certain center frequency and frequency span combinations cause
the swept CW generator to limit the value entered. In general, any
combination that would cause the swept CW generator to exceed its
minimum or maximum specified frequency will be limited.
SCPI:
FREQuency:CENTer
<num>[freq
suffix] or
MAXimumlMINimum(UPIDOWN
FREQuency:MODE SWEep
Analyzer: CF
(SPAN),
(czq,
(STOP)
“Center Frequency/Span Operation” in Chapter 1
Operating and Programming Reference C-l
To Next Page
Loading...
