HP 8360 L Series User Manual

Step Swp Hem
Step Swp Menu
Function Group
Menu Map
Description
FREQUENCY
2
This softkey reveals the stepped frequency sweep entry menu.
Dwell Coupled Couples the dwell time for stepped
sweep points to ramp sweep, sweep
time.
Step Control Master
Step Control Slave
Step Dwell
Step Points
Step Size
Step Sap Pt Trig Auto
Step Sup Pt Trig Bus
Step Swp Pt Trig Ext
Causes the swept CW generator to
act as the master control in a dual
swept CW generator measurement
setup.
Causes the swept CW generator to
act as the slave in a dual swept CW
generator measurement setup.
Sets the dwell time for points in
stepped sweep.
Sets the number of points in a
stepped sweep.
Sets the increment value for the
points in a stepped sweep.
Automatically steps the swept CW
generator to the next point in a
stepped sweep.
Steps the swept CW generator to
the next point in a stepped sweep
when an HP-IB trigger is received.
Steps the swept CW generator to
the next point in a stepped sweep
when an external hardware trigger
is received.
Programming Codes
SCPI: NONE
Analyzer: NONE
See Also (START), (STOP), Sweep Mode Step , [SWEEP TIME)
“Using Step Sweep” in Chapter 1
Operating and Programming Reference S-61

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English