Security Menu
Function Group
SYSTEM
Menu Map
8
Description
This
softkey
accesses the security function softkeys.
Blank Display
Clear Memory
Save Lock
Zero Freq
Turns off the swept CW generator’s data display,
active entry, and message line areas.
Writes alternating ones and zeros over all swept
CW generator state functions and save/recall
registers a selectable number of times, then returns
the swept CW generator to the factory-preset state
of operation.
Disables the save function.
Displays zeros for all accessible frequency
information.
The features listed above together with the softkeys Freq Offset
and Freq Mult provide the swept CW generator with security
controls for a variety of situations. The local lockout (LLO)
programming command adds security when the swept CW generator
is used in an ATE environment. A security calibration constant that
can be accessed through the service adjustment menu (requires a
password for access) is available also. Refer to the HP 8360 B-Series
Swept Signal Generator/HP 8360 L-Series Swept CW Generator
Service Guide for information on calibration constants.
See Also
Softkeys listed above.
“Using the Security Features” in Chapter 1
S-50 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
