Function Group
Menu Map
Description
Programming Codes
See Also
Software Rev
Function Group
Menu Map
Description
Programming Codes
See Also
SYSTEM
8
This softkey displays the swept CW generator’s programming
language, HP-IB address, and firmware date code.
SCPI:
‘IDN?
Analyzer: 01
HP-13 Menu, SCPI COMMAND SUMMARY
SWEEP
7
This
hardkey
selects single sweep mode, aborts any sweep in progress
and initiates a single sweep at a rate determined by the sweep time
function.
If you press
(?iK@
in the middle of a continuous sweep, the sweep is
aborted and the swept CW generator retraces to the starting point
but does not start a sweep. Press [SINGLE) a second time to start the
sweep. The amber LED above the
hardkey
is lit when the function is
on.
SCPI:
1NITiate:CONTinuous
OFF/O
ABORt
INITiate[:IMMediate]
Analyzer: S2
(CONT)
“Continuous, Single, and Manual Sweep Operation” in Chapter 1
“Programming Typical Measurements” in Chapter 1
S-52 Operating and Programming Reference
To Next Page
Loading...
