HP 8360 L Series User Manual

Auto Track
Function Group
POWER, USER CAL
Menu Map 5,9
Description
This softkey optimizes the tracking of the swept CW generator’s
output filter to the oscillator. Use it to maximize RF power output.
The swept CW generator displays: Peaking At : XXXXX MHz, where
XXXXX represents frequency values. Peaking begins at the low
frequency end and steps through to the high end of the frequency
range. Auto Track is complete when the display returns to its
original state. On swept CW generators without a step attenuator
provide a good source match on the RF connector. Use a power
sensor or a 10 dB attenuator. If a good source match is not provided,
the swept CW generator can mistrack because of excessive reflections
at the output.
Programming Codes
SCPI: CALibration:TRACk
Analyzer: SHRP
See Also
Tracking Menu
“Optimizing Swept CW Generator Performance” in Chapter 1
A-22 Operating and Programming Reference

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English