Sweep Mode List
Programming Codes
SCPI: NONE
Analyzer: NONE
See Also
Softkeys listed above.
“Programming Typical Measurements” in Chapter 1
Sweep Mode List
Function Group
Menu Map
Description
Programming Codes
See Also
SWEEP
7
This
softkey
activates the step frequency list mode. To use this type
of sweep, a frequency list must have been entered, otherwise an error
message appears. In this mode, the swept CW generator steps only
those frequencies defined by the frequency list. An asterisk next to
the key label indicates that this feature is active.
SCPI: FREQuency:MODE LIST
Analyzer: SN
CONNECTORS, List Menu
“Creating and Using a Frequency List” in Chapter 1
Operating and Programming Reference S-65
To Next Page
Loading...
Need help?
General
