HP 8360 L Series User Manual

Step Dwell
is active it calibrates the frequency at the end of every frequency
band.
Programming Codes
SCPI:
SWEep:CONTrol:STATe ON]OFFjl]O
SWEep:CONTrol:TYPE SLAVe
Analyzer: NONE
See Also
Step Control Master, Step Sap Menu
Step Dwell
Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
2
This softkey lets you set dwell times for points in the stepped
frequency mode of sweep operation. The dwell time for points in step
frequency sweep may range from 100 ps to 3.2s. The actual time
between points is the sum of dwell and phase lock times.
Select Step Dwell , then use the entry area to enter the desired
value.
SCPI: SWEep[:FREQ uency]:DWELl
<num>[time suffix] or
MAXimumIMINimum
Analyzer: NONE
Step Sup Menu ,
Sweep Mode Step
Operating and Programming Reference S-59

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English