HP 8360 L Series - 1 Getting Started; What Is in this Chapter

1
Getting Started
What Is In This
Chapter
This chapter contains information on how to use the
HP 8360 L-Series Swept CW Generator. The information is
separated into three sections.
Basic For the novice user unfamiliar with the
HP 8360 L-Series Swept CW Generator. This
section describes the basic features of the swept CW
generator.
Note
Advanced
Programming
For the user familiar with swept CW generators,
but not necessarily familiar with how to use the
special features of the HP 8360 L-Series Swept CW
Generator.
For the user wishing to program an HP 8360 L-Series
Swept CW Generator. This section contains
an introduction to Standard Commands
for Programmable Instruments language
(SCPI), Hewlett-Packard’s implementation of
IEEE-488.2-1987, and an introduction to the
Analyzer programming language.
If you are unpacking a new swept CW generator, refer to the
installation suggestions provided in Chapter 3, “Installation”.
Getting Started Introduction l-1