HP 8360 L Series - Programming Language Comparison

Table 3-9. Programming Language Comparison
Description Network Analyzer
Language
SCPI Language
ALC
Leveling mode, external A2
POW:ALC:SOUR DIOD;
:POW:ATT:AUTO OFF
Leveling mode, internal
Leveling mode, mm module
Al
SHA2
POW:ALC INT
POW:ALC:SOUR MMH;
:POW:ATT:AUTO OFF
Leveling mode, power meter A3
POW:ALC:SOUR PMET;
:POW:ATT:AUTO OFF
Enable normal ALC
operation
Al]A2]A3]SHA2 POW:ALC:STAT ON
Disable ALC and control
modulator drive directly
SHA3 POW:ALC:STAT OFF
Set output power, then
disable ALC
SHAl POW:SEAR ON
Uncouple attenuator,
control ALC independently
Frequency
SHPS <num>DB POW:ATT:AUTO OFF;
:POW <num>[DBM]
Set CW frequency CW <num>freq-suffix FREQ:CW <num>[freq-suffix]
;MODE CW
Set start frequency FA <num>freq-suffix FREQ:STAR <num>[freqsuffix]
;MODE SWE
Set stop frequency FB <num>freq-suffix FREQ:STOP <num>[freqsuffix]
;MODE SWE
Set center frequency CF <num>freq-suffix
FREQ:CENT <num>[freqsuffix]
;MODE SWE
Set frequency span DF <num>freq-suffix FREQSPAN <num>[freqsuffix]
;MODE SWE
Set swept mode step size
Set CW mode step size
Enable frequency
offset function
Enable frequency
multiplier function
SHCF <num>freq-suffix
SHCW <num>freq-suffix
SHFB <num>freq-suffix
SHFA <num>
FREQ:STEP <num>[freq-suffix]
FREQ:STEP <num>[freq-suffix]
FREQ:OFFS <num>[freq-suffix]
;OFFS:STAT ON
FREQ:MULT <num>;MULT:STAT ON
Keep multiplication factor on
instrument on/off or preset
Multiplication factor=1 on
nstrument on/off or preset
SHAL
(Refer to user defined preset)
SHIP
(Refer to user defined preset)
Zoom function
SHST
Installation 3-25