Programming Codes
SCPI:
FREQuency:STARt <num>[freq suffix] or
MAXimum]MINimum]UP]DOWN
FREQuency:MODE
SWEep
Analyzer: FA <num>
[HzJKzIMz(Gz]
See Also
@G&7),
Icw_),
FREQUENCY (MENU_), (SPAN,
(@57)
“CW Operation and Start/Stop Frequency Sweep” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Start=Ml
Stop=M2
Function Group
Menu Map
Description
Programming Codes
See Also
MARKER
3
This softkey changes the swept CW generator start frequency to the
frequency value of marker 1, and the stop frequency to the frequency
value of marker 2. The swept CW generator has been reset to these
start/stop values, unlike the softkey Ml--M2 Sweep that changes the
start/stop values only while active.
SCPI: SWEep[:FREQuency]:MARKer:XFER
Analyzer: SHMP
MI--M2 Sweep
“Marker Operation” in Chapter 1
S-54 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
