Function Group
FREQUENCY
Menu Map
2
Description
This
hardkey
lets you set a value for the frequency span in the center
frequency/frequency span mode of swept frequency operation. Press
m,
and use the entry area to enter the desired value. The swept
CW generator sweeps from one half the span below to one half above
the center frequency.
Certain center frequency and frequency span combinations cause
the swept CW generator to limit the value entered. In general, any
combination that causes the swept CW generator to exceed its
minimum or maximum specified frequency is limited.
Programming Codes
SCPI:
FREQuency:SPAN <num>[freq suffix] or
MAXimum]MINimum(UP]DOWN
FREQuency:MODE
SWEep
Analyzer: DF <num> [HzJKzlMzlGz]
See Also
@iiEiQ,
Gi%$,
[jETFj
“Center Frequency/Span Operation” in Chapter
I
Function Group
FREQUENCY
Menu Map
2
Description
This
hardkey
activates swept frequency mode and makes the start
frequency parameter the active function. Press
(??Z?i)
and use the
entry area to enter the desired value. The start/stop frequency must
be separated by at least 2 Hz in order to remain in the frequency
sweep mode. If start=stop frequency then the zero span mode is
entered.
Operating and Programming Reference S-53
To Next Page
Loading...
Need help?
General
