Using
Step
Sweep
1. Refer to menu map 2.
2. Press FREQUENCY [MENU).
3. Select
Step Swp Menu.
4.
Select
Step Size.
Enter the desired increment value.
5.
Select Step Points . Enter the number of points desired.
6.
Determine the dwell time desired, select Step Dwell and enter
a value, or choose the dwell time determined by the ramp mode
sweep time, select
Dwell Coupled.
7.
Determine the triggering scheme, select
Step Swp Pt Trig Auto ,
Bus,or
Ext.
8. Press SWEEP (MENU_).
9.
Select Sweep Mode Step, to activate the step frequency mode.
Getting Started Advanced 1-51
To Next Page
Loading...
Need help?
General
