HP 8360 L Series User Manual

Sweep Mode Ramp
Function Group
SWEEP
Menu Map 7
Description
This softkey activates the analog frequency sweep mode. Ramp
sweep mode is the factory preset state. An asterisk next to the key
label indicates that this feature is active.
Programming Codes
SCPI:
FREQuency:MODE SWEep
SWEep[:FREQ
uency]:GENeration ANALog
Analyzer: NONE
See Also
CONNECTORS, (EiF), Manual Sweep,[$?TF),
“Programming Typical Measurements” in Chapter 1
Sweep Mode Step
Function Group
SWEEP
Menu Map 7
Description
This softkey activates the stepped frequency step mode. In this
mode, the swept CW generator steps from the start frequency to
the stop frequency, by the designated frequency step size. Manual,
continuous, and single sweeps can be performed in this mode. An
asterisk next to the key label indicates that this feature is active.
Programming Codes
SCPI:
FREQuency:MODE SWEep
SWEep[:FREQ
uency]:GENeration STEPped
Analyzer: NONE
See Also
I??%), Manual Sweep,(K), Step Sup Menu
“Using Step Sweep” in Chapter 1
S-66 Operating and Programming Reference

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English