HP 8360 L Series - Saving and Recalling an Instrument State

Saving and
The save/recall registers store and access a previously set instrument
Recalling an
state.
Instrument State
For example, set the swept CW generator to sweep from 3 to 15
GHz at a -10 dB power level, with markers 1 and 2 set at 4.5 and
11.2 GHz.
Press (START) (?J LGHz).
Press LSTOP) (iJ @ (GHz).
Press (POWER LEVEL) (-) (iJ (TJ IdBo).
Press
(MARKER).
Select Marker Ml @ 0 @ IGHz).
Select Marker M2 (iJ 0 0 @ LGHz).
To save this instrument state in register 1, press (SAVE] (iJ. To verify
that the swept CW generator has saved this state:
Press
[PRESET).
Press IRECALL] 0.
Press
(MARKER).
The active entry area displays:
--> RECALL REGISTER: 1 RECALLED
Notice the sweep end points, power level, and the asterisks next to
the marker 1 and 2 key labels.
You can save instrument states in registers 1 through 8. Register
0 saves the last instrument state before power is turned off. When
power is turned on, register 0 is automatically recalled.
1-16 Getting Started Basic