HP 8360 L Series User Manual

Marker 1 was chosen because it is selected as the delta marker
reference. To change reference markers, select Delta Mkr Ref .
Select M2 as the reference. Watch the display change to indicate:
--> DELTA MKR (3-2) : 1200.000000 MHz
You can choose any of the five markers as a reference, but when delta
marker is on, if the reference marker has a frequency value higher
than the last active marker, the difference between the frequencies is
negative and is displayed as such by the swept CW generator. The
CRT display continues to intensify the difference between the two
markers.
When delta marker is showing in the active entry area, the ENTRY
area is active. Rotate the rotary knob and watch the frequency
difference change. The last active marker (in this case, marker 3)
changes frequency value, not the reference marker.
OSCILLOSCOPE
Figure 1-8. Marker Operation
Marker Operation
Delta Marker
Operation
1. Press (jiXi?K).
2. Select a marker key (Ml . MS ).
3. Enter value.
4. Press terminator key.
1. Press ($iZKKj.
2. Select a marker key (MI ~5).
3. Enter value.
4. Press terminator key.
5. Select a different marker key ( Mi M5 ).
6. Enter value.
7. Press terminator key.
8. Select Delta Hkr Ref.
9. Select one of the previously chosen markers.
10. Press IPRIOR).
11. Select Delta Marker
Getting Started Basic l-15

HP 8360 L Series Specifications

General

Brand	HP
Model	8360 L Series
Category	Inverter
Language	English