Changing
the
Preset
1. Set up the swept CW generator in the desired operation state to
Parameters
be used as the preset state.
2. Refer to menu map 8.
3. Press SYSTEM (MENU).
4.
Select Save User Preset .
5.
Select Preset Mode User.
Whenever the
(w]
key is pressed, the swept CW generator will
return to the operation state setup and saved in steps 1 and 4. The
swept CW generator displays:
***
USERDEFINEDPRESETRECALLED ***
and also gives you the option of selecting the factory preset state by
creating a factory preset softkey.
1-54 Getting Started Advanced
To Next Page
Loading...
Need help?
General
