S
I
SAVE
1
Function Group
Menu Map
Description
Programming Codes
See Also
SYSTEM
8
This
hardkey
allows up to eight different front panel settings to
be stored in memory registers 1 through 8. Swept CW generator
settings can then be recalled with the
[RECALL)
key. A memory
register can be alternated with the current front panel setting using
the Atrnate Regs soft key.
The information stored in memory registers is retained in memory
indefinitely when ac line power is constantly available, or for
approximately three years without line power. Pressing
(m)
does
not erase the memory registers (1 through 8).
Register 0 is a memory register also. It saves the last front panel
settings automatically and can not be accessed through the
ISAVE)
key. Likewise, register 9 is reserved for user preset storage and can
not be accessed with the (SAVE) key. Pressing
(PRESET)
erases register
0, but not register 9.
SCPI: *SAV <num>
The above is an IEEE 488.2 common command.
Analyzer: SVn, where
n=
a numeric value from 1 to 8.
Altrnate Aegs , Clear Memory,
(m),
Save Lock
“Saving and Recalling an Instrument State” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Operating and Programming Reference S-l
To Next Page
Loading...
Need help?
General
