HP 8360 L Series - Page 396

Table 3-9. Programming Language Comparison (continued)
Description
Network Analyzer
SCPI Language
Language
Set remote knob
RB
Request status byte mask
RE <num>,RM <num>
*SRE <num>, *SRE?,
*ESE <num>, *ESE?
Reset sweep
RS
ABOR
Number of steps in SN <num> SWE:POIN <num>
a stepped sweep
Swap network analyzer
SW <110>
channels
Test HP-IB interface
Sets sweep time lower limit
Take sweep
hstrument State
:nstrument preset
4cal instrument control
Markers [n] is 1 to 5, 1 is default
Iurn on and set marker
Turn off frequency marker
Enable Ml-M2 sweep
Disable Ml-M2 sweep
Move start->Ml stop->M2
3nable delta marker
disable delta marker
Move marker to
:enter frequency
furn off all markers
Iurn on amplitude markers
l’urn off amplitude markers
TI <num> DIAG:TINT? <num>
TL <num>time-suffix SWE:TIME:LLIM <num>[time-suffix]
TS
TSW;*WAI
IP
LOCAL 7XX
SYST:PRES
LOCAL 7XX
(XX=Source HP-IB address)
Mn <num>freq-suffix
MnMO
MPl
MPO
SHMP
MD1
MD0
MC
SHMO
AK1
AK0
MARK[n]:FREQ
<num>[freq-suffix]
STAT ON
MARK[n] OFF
SWE:MARK:STAT ON
SWE:MARK:STAT OFF
SWE:MARK:XFER
MARK[n]:DELT? <num>,<num>
MARK OFF
MARK[n]:FREQ?;
:FREQ:CENT <response>[freqsuffix]
MARK:AOFF
MARK[n]:AMPL ON
;AMPL:VAL <num>[DB]
MARK:AMPL OFF
Installation 3-27