Table 3-9. Programming Language Comparison (continued)
Description
System
Recall an instrument state
Save an instrument state
Activate alternate
state sweep
Deactivate alternate
state sweep
Display software revision
Select an internal
frequency reference
Select an external
frequency reference
Display/set HP-IB address
Select SCPI
Select network analyzer language
Select CIIL
Lock save/recall registers
Unlock save/recall registers
Purge all instrument memory
Blank instrument display
Network Analyzer
Language
RC
<O-9>
sv
<l-9>
AL1 <I-9>
AL0
(cycle power)
(hardware)
[hardware)
rfront
panel/hardware)
jYST[SCPIl
3YST:LANG
COMPl
2IIL (Or hardware)
jHSV
jHRC
SHMZlSHZ SHKZOHZ
IUO
SCPI Language
*RCL
<O-8>
*SAV <l-S>
SYST:ALT
<l-8>;ALT:STAT
ON
SYST:ALT:STAT OFF
*IDN?
(See SCPI common commands)
ROSC INT
ROSC EXT
SYST:COMM:GPIB:ADR
<num>
(or hardware switch)
YYST:LANG
SCPI (or hardware switch)’
SYST:LANG
SOMPl
SYST:LANG
CIIL (or hardware switch)
3YST:KEY:DIS SAVE
3YST:KEY:ENAB SAVE
3YST:SEC
0N;SEC
OFF
3ISP OFF
L
Wait one second after executing this command before sending any additional commands or they may be lost or ignored.
Installation 3-29
To Next Page
Loading...
