HP 8360 L Series - Page 415

G global dwell
list array, G-l
global offset
list array, G-l
GP-IB
analyzer language, P-13
CIIL language, P-13
printer address, P-11
SCPI programming, P-14
trigger, frequency list, L-8
GP-IB address
changes to, 3-8
factory-set, 3-7
power meter, M-8
GPIB address
swept CW generator, A-l, E-l
GP-IB check, example program, I-90
GP-IB connector, C-6
GP-IB control functions, H-l
GP-IB trigger
stepped sweep mode, S-62
sweep mode, S-55
grounding pin, 3-4
Group Execute Trigger, 1-119
group execute trigger command, S-15
H
HP 437B
detector calibration, E-5
programming address, M-8
HP 437B, flatness correction measure all, M-7
HP 437B, measure correction, M-7, M-8
HP 437B measure correction functions, M-13
HP 8340
status register, A-13
HP 8340/41 system convert to HP 8360 system, 3-19
HP 8355~series interface connector, C-8
HP 83550 series system connections, 3-22
HP 8360 as controller, 3-7
HP 8510 system connections, 3-21
HP 8516A interface connector, C-5
HP 8757C/E system connections, 3-21
HP 8970B system connections, 3-22
HP-IB
analyzer language, P-13
CIIL language, P-13
printer address, P-l 1
SCPI programming, P-14
technical standard, l-120
trigger, frequency list, L-8
HP-IB address
changes to, 3-8
factory-set, 3-7
power meter, M-8
swept CW generator, A-l, E-l
Index-10