HP P2000 G3 MSA System CLI Reference Guide 163
controller a|b
Optional. For IP-related parameters, this specifies whether to apply settings to controller A or B. If this
parameter is omitted, settings are applied to the controller being accessed. This parameter does not
apply to Ethernet switch-related parameters, whose settings are always applied to the controller
being accessed.
ping-broadcast enabled|disabled|on|off
Optional. Enables the storage system to respond when a ping to a broadcast address is issued on
the system’s subnet.
link-speed 10mbps|100mbps
Optional. Specifies the maximum link speed for auto-negotiation.
• 10mbps: Sets the link speed to 10 Mb/s.
• 100mbps: Sets the link speed to 100 Mb/s. If this parameter is omitted and a port’s link speed
is not set, it will be set to 100 Mb/s.
duplex-mode full|half
Optional. Specifies the duplex mode.
• full: Sets the port to use full duplex. If this parameter is omitted and a port’s duplex mode is not
set, it will be set to full duplex.
• half: Sets the port to use half duplex.
auto-negotiation enabled|disabled|on|off
Optional. Specifies whether to auto-negotiate the link speed.
• enabled or on: Enables auto-negotiation. If you enable auto-negotiation you must also specify
the link-speed parameter to set the maximum supported speed for auto-negotiation. Because
the controller will choose the proper duplex mode for the negotiated speed, you cannot specify
the duplex-mode parameter.
• disabled or off: Disables auto-negotiation. If you disable auto-negotiation and don’t specify
the link-speed and duplex-mode parameters, the controller will use the current settings of
the network port.
If this command is specified and the auto-negotiation parameter is omitted, auto-negotiation
will be enabled.
prompt yes|no
Optional. For scripting, this specifies an automatic response to the confirmation prompt that appears
when an Ethernet switch parameter is changed:
• yes: Allow the command to proceed.
• no: Cancel the command.
If this parameter is omitted, you must manually reply to the prompt.
noprompt
Optional in console format; required for XML API format. Suppresses the confirmation prompt that
appears when an Ethernet switch parameter is changed, which requires a yes or no response.
Specifying this parameter allows the command to proceed without user interaction.
Example Use DHCP to set network port IP values:
# set network-parameters dhcp
Success: Command completed successfully. - Request to set network parameters has
been initiated. (2011-10-12 12:26:45)
Manually set network port IP values for controller A (disabling DHCP for both controllers, if it was
enabled):
# set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway
192.168.0.1 controller a
Success: Command completed successfully. - Request to set network parameters has
been initiated. (2012-01-21 12:26:50)
To Next Page
Loading...
Need help?
General
