164 Alphabetical list of commands
For the controller you are accessing, set the network port to auto-negotiate with a maximum link
speed of 100 Mb/s:
# set network-parameters auto-negotiation on link-speed 100mbps
WARNING: You are attempting to change the Ethernet settings for this Management
Controller, which will affect the link speed and duplex mode settings. Are you
sure? yes
Success: Command completed successfully. - Request to set network parameters has
been initiated. (2012-10-18 15:38:10)
For the controller you are accessing, for which auto-negotiation is disabled, set the network port to
use a maximum link speed of 10 Mb/s and half-duplex mode:
# set network-parameters link-speed 10mbps duplex-mode half
WARNING: You are attempting to change the Ethernet settings for this Management
Controller, which will affect the link speed and duplex mode settings. Are you
sure? yes
Success: Command completed successfully. - Request to set network parameters has
been initiated. (2012-10-18 15:38:35)
See also • show network-parameters
To Next Page
Loading...
