194 Alphabetical list of commands
Example Show advanced system-configuration settings:
# show advanced-settings
Vdisk Background Scrub: Enabled
Vdisk Background Scrub Interval: 24
Partner Firmware Upgrade: Disabled
Utility Priority: High
SMART: Enabled
Dynamic Spare Configuration: Disabled
Enclosure Polling Rate: 5
Host Control of Caching: Enabled
Sync Cache Mode: Immediate
Independent Cache Performance Mode: Disabled
Missing LUN Response: Not Ready
Controller Failure: Disabled
Supercap Failure: Enabled
CompactFlash Failure: Enabled
Power Supply Failure: Disabled
Fan Failure: Disabled
Temperature Exceeded: Disabled
Partner Notify: Disabled
Auto Write Back: Enabled
Drive Spin Down Non-Vdisk Enable: Enabled
Drive Spin Down Non-Vdisk Delay: 30
Disk Background Scrub: Disabled
Managed Logs: Disabled
Success: Command completed successfully. (2012-01-18 14:29:38)
Basetypes • advanced-settings-table
• status
See also • set advanced-settings
To Next Page
Loading...
