HP P2000 G3 Cli Reference Guide

274 Alphabetical list of commands
Primary-Volume-Status
Primary volume status: Online, Offline, Conflict, or N/A.
MaxQueue
Maximum number of replication images to consider when determining the next image to replicate.
Used only if the On Collision parameter is set to Oldest.
The default is 32.
MaxRetryTime
Maximum amount of time in seconds that the replication volume should retry a replication operation
on any specific image when errors occur. Used only if the On Error parameter is set to Retry.
The
default is 1800.
On Error
Error policy to invoke when errors occur during the replication process:
• Retry: Retry the replication for the time specified by the MaxRetryTime value. This is the
default.
• Suspend: Suspend the replication until the error is resolved automatically or through user
intervention.
Link Type
Type of ports used to link the primary and secondary volumes:
• FC: FC ports.
• iSCSI: iSCSI ports.
On Collision
Collision policy used to determine the next image to replicate when multiple replication images are
queued:
• Newest: Only the latest replication image should be considered for the next replication
operation.
• Oldest: Only the latest n replication images should be considered for the next replication
operation, where n is defined by the MaxQueue value and the oldest of these images should be
considered first. This is the default.
Monitor Interval
Interval in seconds at which the primary volume should query the secondary volume.
The default is
300.
Priority
Priority of the replication process on the replication volume:
• High: Replication has higher priority than host I/O. This can cause heavy I/O to be slower than
normal. This is the default.
• Medium: Replication performance is balanced with host I/O performance.
• Low: Replication runs at a slower rate with minimal effect on host I/O. Use when streaming data
without interruption is more important than data redundancy.
Connection Status
• Not Attempted: Communication has not been attempted to the remote volume.
• Online: The volumes in the replication set have a valid connection but communication is not
currently active.
• Active: Communication is currently active to the remote volume.
• Offline: No connection is available to the remote system.
Connection Time
Date and time of the last communication with the remote volume, or N/A.

HP P2000 G3 Specifications

General

Model	P2000 G3
Category	Storage
Drive Support	SAS, SATA
Host Interface	iSCSI, Fibre Channel, SAS
Form Factor	2U
RAID Levels	0, 1, 5, 6, 10
Cache	2 GB
Drive Bays	12 (SFF), 24 (SFF), 12 (LFF)
Cache Memory	2GB per controller
Operating Temperature	10°C to 35°C
Power Supply	Redundant
Expansion Options	Disk Enclosures