334 Alphabetical list of commands
State
• AVAIL: Available.
• FAILED: The disk is unusable. Reasons for this status include: excessive media errors; SMART
error; disk hardware failure; unsupported disk.
• GLOBAL SP: Global spare.
• LEFTOVR: Leftover.
• VDISK: Used in a vdisk.
• VDISK SP: Spare assigned to a vdisk.
Partially Reconstructed
• True: The disk contains partially reconstructed data.
• False: The disk does not contain partially reconstructed data.
Out Of Sync
• True: The disk data is out of sync with other disks in the vdisk.
• False: The disk data is in sync with other disks in the vdisk.
Age
The age of the disk in the vdisk. The age value starts at 1 and is incremented for all good disks in the
vdisk each time there is a change in the disk configuration of the vdisk, such as when a disk is
detected to have failed or be missing. Therefore, if a disk has a lower age than other disks in the
vdisk, that disk is out-of-sync with the other vdisk members. This value can be used as a guide to
decide which disks to physically remove before doing the trust operation to minimize the amount of
corrupt data in the trusted vdisk if you want to use the unsafe parameter.
Example Trust a vdisk which has enough good disks to complete the trust operation. The vdisk may have
out-of-sync or partially reconstructed disks but they are not needed to complete the trust operation.
The command completes successfully.
# trust enable
Success: Command completed successfully. - Trust is enabled. (2013-09-17
04:29:28)
# trust vdisk VD1
Success: Command completed successfully. (VD1) - Trust operation completed
successfully for this vdisk. (2013-09-17 04:29:35)
Trust a vdiskwhich does not have enough good disks available to complete the trust operation. The
command fails.
# trust enable
Success: Command completed successfully. - Trust is enabled. (2013-09-17
04:12:49)
# trust vdisk VD1
Error: The trust operation failed because the vdisk has an insufficient number
of in-sync disks. - Please contact Support for further assistance.
(2013-09-17 04:13:13)
Trust a vdisk which has out-of-sync or partially reconstructed disks that would be needed to complete
the trust operation. The command fails.
# trust enable
Success: Command completed successfully. - Trust is enabled. (2013-09-17
09:06:41)
# trust vdisk VD1
Error: Command failed. - The vdisk specified contains out-of-sync or partially
reconstructed disks that are necessary to restore the vdisk to an accessible
state. Continuing with the trust operation may lead to data corruption. Please
contact Support for further assistance. (2013-09-08 09:06:46)
To Next Page
Loading...
Need help?
General
