66 Alphabetical list of commands
units auto|MB|GB|TB
Optional. Sets the unit for display of storage-space sizes:
• auto: Sizes are shown in units determined by the system. This is the default.
• MB: Sizes are shown in megabytes.
• GB: Sizes are shown in gigabytes.
• TB: Sizes are shown in terabytes.
Based on the precision setting, if a size is too small to meaningfully display in the selected unit,
the system uses a smaller unit for that size. For example, if units is set to TB, precision is set to
1, and base is set to 10, the size 0.11709 TB is instead shown as 117.1 GB.
name
A name for the new user, which cannot already exist in the system. The name is case sensitive;
cannot include a comma, double quote, backslash, or space; and can have a maximum of 29 bytes.
NOTE: The user name admin is reserved for internal use.
Example Create user John who will view system information using base 2 in SMU:
# create user base 2 interfaces wbi level monitor John
Enter new password: ********
Re-enter new password: ********
Success: Command completed successfully. (John) - The new user was created.
(2012-01-20 15:54:35)
Create user MIB that can view the SNMP MIB, using authentication and encryption:
# create user interfaces snmpuser password Abcd1234 authentication-type SHA
privacy-type AES privacy-password Abcd5678 MIB
Success: Command completed successfully. (MIB) - The new user was created.
(2012-01-20 15:54:45)
Create user Traps that can receive SNMP trap notifications, using authentication without
encryption:
# create user interfaces snmptarget authentication-type MD5 trap-host
172.22.4.171 Traps
Enter new password: *********
Re-enter new password: *********
Success: Command completed successfully. (Traps) - The new user was created.
(2012-01-20 15:54:55)
See also • set snmp-parameters
• set user
• show users
To Next Page
Loading...
Need help?
General
