â– [no] vlan VLAN-ID ip rip IP-ADDR
Specify the IP address the request is for.
Next Available Options:
â– authentication-type < none | text > -- Set authentication type used on this interface.(p. 718)
â– authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 717)
â– metric < 1 to 15 > -- Set metric for this interface.(p. 734)
â– poison-reverse -- Enable/disable poison reverse on this interface.(p. 741)
â– receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 745)
â– send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
747)
â– rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 747)
â– vlan VLAN-ID ip pim-dense ip-addr
Usage: ip pim-dense [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-DM packets sent out on this
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP conîš¿guration. The default is 'any'.
This command also enable the PIM-DM protocol on the VLAN interface.
Next Available Options:
â– ip-addr -- Specify IP address. (IP-ADDR) (p. 729)
â– any -- Dynamically determine IP address.(p. 716)
â– vlan VLAN-ID ip pim-dense ip-addr IP-ADDR
Specify IP address.
â– vlan VLAN-ID ip pim-sparse ip-addr
Usage: ip pim-sparse [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-SM packets sent out on this
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP conîš¿guration. The default is 'any'.
This command also enable the PIM-SM protocol on the VLAN interface.
Next Available Options:
â– ip-addr -- Specify IP address. (IP-ADDR) (p. 729)
â– any -- Dynamically determine IP address.(p. 716)
â– vlan VLAN-ID ip pim-sparse ip-addr IP-ADDR
Specify IP address.
â– [no] vlan VLAN-ID vrrp vrid < 1 to 255 > virtual-ip-address IP-ADDR/mask-LENGTH
Specify IP address/mask.
730© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General