426
Ste
Command
Remarks
5. Configure a filtering policy to
filter the redistributed routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ bgp4+ | direct | isisv6
process-id | ospfv3 process-id |
ripng process-id | static ]
Optional.
By default, redistributed routes are
not filtered.
6. Return to system view.
quit N/A
7. Enter interface view.
interface interface-type
interface-number
N/A
8. Enable the OSPFv3 process
on the interface.
ospfv3 process-id area area-id
[ instance instance-id
]
Disabled by default.
Configuring IPv6 IS-IS between IPv6 MCE and PE
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Create an IS-IS process for an
IPv6 VPN instance and enter
IS-IS view.
isis [ process-id ] vpn-instance
vpn-instance-name
N/A
3. Configure a network entity
title.
network-entity net Not configured by default.
4. Enable the IPv6 capacity for
the IS-IS process.
ipv6 enable Disabled by default.
5. Redistribute the VPN routes.
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
Optional.
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.
6. Configure a filtering policy to
filter the redistributed routes.
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name }
export [ protocol [ process-id ] ]
Optional.
By default, IPv6 IS-IS does not filter
redistributed routes.
7. Return to system view.
quit N/A
8. Enter interface view.
interface interface-type
interface-number
N/A
9. Enable IPv6 for the IS-IS
process on the interface.
isis ipv6 enable [ process-id ] Disabled by default.
Configuring EBGP between IPv6 MCE and PE
Ste
Command
Remarks
1. Enter system view.
system-view N/A