Huawei TaiShan 2280 V2 - Connecting a Serial Cable

Figure 4-10 Connecting a USB device
----End
4.5.5 Connecting a Serial Cable
The rear panel of the server provides a standard RJ45 serial port (three-pin serial port), which
works as the system serial port by default. You can set it as the iBMC serial port using the
iBMC CLI.
The serial port can be used as:
l System serial port to monitor the OS status
l iBMC serial port for debugging and fault locating
Procedure
Step 1 Wear an ESD wrist strap. For details, see 12 Preventing Electrostatic Discharge.
Step 2 Plug the connector into the serial port. See Figure 4-11.
TaiShan 2280 V2 Server
User Guide
4 Setup
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 64