4 Setup
4.1 Environmental Requirements
4.2 Unpacking the Chassis
4.3 Installing Optional Parts
4.4 Installing the Server on Guide Rails
4.5 Connecting External Cables
4.6 Initial Configuration
4.1 Environmental Requirements
NOTE
l For details about the safety precautions to be observed when you install or replace servers and their
parts, see the Server Safety Information.
l Suitable for mounting on concrete or other non-combustible surface only.
4.1.1 Space and Airflow Requirements
To allow for servicing and adequate airflow, observe the following space and airflow
requirements:
l Install the server in an access-restricted area.
l Keep the area in which the server is located clean and tidy.
l To facilitate heat dissipation and maintenance, keep a clearance of 800 mm (31.50 in.)
between walls and the front and rear doors of the cabinet.
l Do not block the air intake vents. Otherwise, air intaking and heat dissipation will be
affected.
l The air conditioning system in the equipment room provides enough wind to ensure
proper heat dissipation of all components.
The server draws in cool air from the front of the cabinet and exhausts hot air from the rear.
Therefore, the front and rear of the cabinet must be well ventilated for optimal heat
dissipation. Figure 4-1 shows the direction of heat dissipation.
TaiShan 2280 V2 Server
User Guide
4 Setup
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 54
To Next Page
Loading...
